Bentel Omnia 4 Manuale Utente Scaricare il pdf (Pagina 6)

BENTEL

USER MANUAL

1. Your system can be remotely ARM from outside the house through any normal DTMF

telephone or GSM hand phone.

2. Please refer to Telephone Control Program below.

DTMF Program Telephone On/Off

Enter user password 0001, press ENTER.

Select (En./Dis.Ans.Func), press ENTER.

Press the ON key to enable.

Note: Once the Telephone Access Code has been recognized, enter the command (0002), same

as [user code 2], there will be a beep sound. Then press:-

(i) Press 4 Will Beep Twice And Press 0 To Disarm. Then press #

(ii) Press 4 Will Beep Twice And Press 2 To Disarm. Then press #

(iii) Press 4 Will Beep Twice And Press 5 To Hear Status. Beep One Time Is Off,Beep

twice is On B mode.Then press #,Last press * To End The Call.

There are various options for disarming the system:

a. Keypad Disarming

b. Remote Control Disarming

c. Telephone Remote Disarm

[USER CODE 1] + [OFF]

1. To disarm the system, enter a valid 4-6 digit [USER CODE 1] followed by [OFF] key

before expiry of the entry delay time.

2. Enter the premises through a designated ENTRY/EXIT zone; entering via other zones

will trigger an alarm instantly.

3. The ENTRY delay begins once the ENTRY zone is violated.

4. The keypad audible indicator will sound for the duration of the ENTRY delay to indicate

that a valid user code is required.

5. If the ARMED indicator remains illuminated, an error has been made while entering the

user code, please re-enter the user code 1 and press off button.

6. Once the system is disarmed, the ARMED indicator will extinguish and the keypad

audible indicator will stop.

7. If no valid user code has been entered by the end of the ENTRY delay period, an

ALARM condition will be registered and stored into the system MEMORY.

8. If the ENTRY delay is too short, have your installer to change the ENTRY delay period.

KEYPAD DISARMING

DISARMING THE SYSTEM

TELEPHONE REMOTE ARMING / DISARM

1 2 3 4 5 6 7 8 9 10

Nessun commento

Bentel Omnia 4 Manuale Utente Pagina 6